817-483-9883

Drummond Diaphragm Replacement

Drummond Diaphragm Replacement Instructions

Drummond Diaphragm and Hinge Kit: DR 4-000-010

Table Top Models: DR 4-000-110, DR 4-000-111, DR 4-000-220, DR 4-000-221

Instructions for Drummond Diaphragm Replacement. Step 1: remove screws. Step 2: Diaphragms. Step 3: Push diaphragm to center of case. Step 4: Use pliers to grip magnetic arm near rubber bushing. Step 5: pull straight up, removing arm and diaphragm. Step6: grip diaphragm and pull off center screw
Step 7: wet center hole with water. Step 8: use thumb to force diaphragm over screw. Step 9: twist to secure diaphragm to magnetic arm. Step 10: center crew should be fully visible. Step 11: use pliers to replace arm and bushing. Step 12: Push diaphragm full onto housing. Step 13: use flat blade screwdriver to attach diaphragm.

Disclaimer: Any action you take using the information on this website is strictly at your own risk. The information herein does not constitute professional advice and is general in nature. We make no warranty that this information will meet your requirements, be safe, accurate, or error-free. Pipette Supplies, Inc. is not responsible for any errors or omissions, any results obtained from the use of this information, or any loss or damage arising out of the use of this information. This site is for educational purposes only.
Fair Use: Copyright Disclaimer under section 107 of the Copyright Act of 1976, allows for “fair use” for purposes such as comments, criticism, teaching, scholarship, news reporting, and research.
Fair use is permitted by copyright statute that might otherwise be infringing.

Leave a Reply

Your email address will not be published. Required fields are marked *

0